The "Marston" range is of Wide Beam sailaways are built on our own design of shell to a high specification and represent outstanding value for money. All of these craft conform to the Recreational Craft Directive and come with pressure tested diesel tanks.

All of our sailaways come with a choice of window layouts, with engines fitted. We fit the CANALINE range of engines as standard, but will also also fit your own choice of engine if required.

The "Sailaway Standard" is battoned sprayfoamed and ballasted, with floor, windows and mushroom vents installed. STEEL front, rear and side doors COME AS STANDARD. These craft are for the more ambitious fitter.

The "Sailaway Lined" is as per the "Sailaway Standard", but lined in PROFESSIONALLY SPRAY LAQUERED oak panel with SOLID OAK TRIMMING throughout. FULL 12v and 240v wiring looms are also installed.

The "Sailaway Additions" is as per the "Sailaway Lined", but with an 1800w Inverter installed and working, diesel fired central heating installed and connected to up to three radiators and a calorifier, water pump and all plumbing runs installed to tails.

We also offer an extensive range of options, including exterior painting and a fully fitted bedroom bathroom or galley should you require one.

These are very attractive boats, at incredible prices that we believe that no other supplier can match for equivalent quality. Our lead times are kept as short as possible and all boats come with full warranty backup.

All prices quoted include VAT.

Specifications

Sailaway Standard

Cruiser stern

10 (base) : 6 (hull) : 5 (cabin) : 4 (roof) steel shell, in primer, with hull blacked

Steel front doors, steel rear doors and hatch and steel side doors

3 x 2” rubbing strakes, one full length

Steel plank & pole rack

Vented Gas locker at bow

Vented Diesel Tank at rear

Self draining front and rear decks

Quick Release Weed Hatch

Steel centre rope eye

Front, rear and side fender eyes

4 x brass mushroom vents

Fully windowed and/or portholed, in your choice of positions, gold anodized colour (7 up to 50', 9 for 51' and over. Additional windows or ports available as an option)

Integral steel water tank (stainless steel water tank option available)

Canaline 52 h.p. engine (optional upgrade to Canaline 70 h.p. or to the engine of your choice also available.)

Initial ballast laid beneath floor (either complete paving flags or concrete common bricks. You will need to install final trim ballast at the end of the build process)

Far-Eastern ply flooring installed, including 4” strip either side of boat to allow floor to be lifted for final ballast adjustments after the hull lining has been installed

Battoned (including roof & hull sides), ready for you to attach your lining to

Sprayfoam insulated above floor board level throughout

Sailaway Lined (Also Known as the "Sailaway Plus")

As per Sailaway Standard with the following:

Hull, Cabin and Roof lined in oak faced ply with SOLID OAK trims. ALL panels and trims are pre-sprayed with professional finish 2 pack wood laquer / varnish.

2 full height and one half height bulkheads installed to your choice of positions.

FULL 12v wiring loom installed (NOT JUST “WIRING TAILS”)

FULL 240v circuit installed, including landline socket, consumer unit, 240v wiring behind panels and 4 x 2 gang brass sockets.

Tunnel light and horn installed and working

Sailaway Additions

As per the Sailaway Plus with the following:

1800w Pure Sine Wave Inverter Installed & Working

Diesel fired central heating fully installed, including up to three radiators

Calorifier installed and connected to engine and diesel central heating. Plumbing runs installed (including water pump) ready to connect tails for shower / sink / washbasin

Prices (inclusive of VAT at 20%)

Please note that the specifications, prices and options listed are correct a the time of writing. Any of these may be altered at any time without notice. Prices exclude delivery costs to the marina of your choice. This price list does not constitute any contract or part of any contract and is for guidance only. The exact price of your boat will be confirmed in writing with you at the time of placing your order.

Options

Bow Lockers (pair) £ 595

Stainless Steel Water Tank £1,095

Additional windows or portholes (each) £350

Additional Mushroom Vents (each) £115

Additional bulkheads (each) £600

Solid Fuel Stove installed £1,350

Upgrade to Canaline 70 h.p., Beta Marine Greenline 60 or 75 h.p. engine (incl. PRM 260) £POA

Vetus 95 bow thrusters installed and working £3,995

Quality 12v panel using CarlingSwitch ™ circuit breakers, installed and
Wired £1,050

1200w inverter installed and working £1,495

1800w inverter installed and working £1,995

3000w inverter installed and working (incl. extra batteries) £2,495

3.5kw 240v engine mounted generator £3,995

Diesel fired central heating fully installed including 3 radiators £3,495

Calorifier installed & connected to engine and diesel boiler. Plumbing runs installed (including water pump) ready to connect tails for sink / shower / washbasin £2,495

Washing machine housing including all plumbing £845

Fully fitted bathroom £POA

Fully fitted galley £POA

Fully fitted bedroom £POA

Exterior painting £POA

Please note that the specifications, prices and options listed are correct a the time of writing. Any of these may be altered at any time without notice. Prices exclude delivery costs to the marina of your choice. This price list does not constitute any contract or part of any contract and is for guidance only. The exact price of your boat will be confirmed in writing at the time of your order.

The Northwich Boat Company is a trading name of Elton Moss Boatbuilders Limited
Moss Bridge Cottage, Elton Moss Canal Bridge, Sandbach, Cheshire. CW11 3PW
Telephone : 01270 760 160
Registered in England & Wales, Number 05403347